8th Floor, L&C Annex, 401 Church Street
Nashville, TN 37243-1551
1-800-734-3619 or email: bgsbeap@tn.gov
SBEAP Home
TDEC's Self Disclosure Policy
Sample Request for Monetary Penalty Waiver
Compliance Advisory Panel
Emerg. Planning & Community Right to Know Act
Energy conservation and efficiency
Hazardous Air Pollutants list
Risk Mgt. Program - Clean Air Act Section 112(r)
Publications
Spill Prevention Control & Countermeasures Plan
What's new?
NESHAP (MACT) standards by affected source category
Asphalt
Hot Mix Asphalt Plants
Processing and Roofing Products Manufacturing
Boiler
Chemicals
Chemical Manufacturing
Drycleaning
Hospital Sterilizers
Metals
Al, Cu, and Nonferrous Foundries
Chromium Electroplating
Ferroalloy Production Facilities
Metal Fabrication and Finishing
Plating and Polishing
Paint
Paints and Allied Products Manufacturing
Surface Coating and Paint Stripping
Ready Mix Concrete
Reinforced Plastic Composites
Retail Gasoline Marketers
RICE Engines
Risk Management Program
Solid/Hazardous Waste
Storm Water Management
Construction: NPDES permit brochure
ECOS: Small Communities
Asphalt Processing and Asphalt Roofing Products Manufacturing
**Final Area Source Rule for Asphalt Processing and Roofing Products **
New! Notice to Owners and Operators of Asphalt Processing and Roofing Products Manufacturing at small/area sources
The Environmental Protection Agency (EPA) made effective an Area Source Rule on December 2, 2009, National Emission Standards Hazardous Air Pollutants (NESHAPs) for asphalt processing and roofing products manufacturing. The rule applies to operations that may produce polycyclic aromatic hydrocarbons (PAH), a hazardous air pollutant (HAP). The rule particularly covers ONLY sources where the primary activity of the facility is Asphalt Processing or Roofing Products manufacturing. Affected facilities are identified by NAICS codes 324110 and 324122.
This rule applies to any facility with a primary operation in one of the above NAICS code(s). For review of the rule – see link: http://www.epa.gov/ttn/atw/area/fr02de09.pdf
Asphalt processing and roofing products facilities should review the rule and submit an initial notice by April 1, 2010, to state whether or not the rule applies to their facility operation. The notice should be submitted to the Tennessee Air Pollution Control Office and the EPA. Sources located in a local air pollution control program area (Knox, Shelby, Davidson or Hamilton counties) should contact the appropriate local air pollution control agency for instructions.
Affected facilities are required to be in compliance by December 2, 2010. New sources must be in compliance when they begin to operate. To verify compliance the owner/ operator may need to meet emission limits by pollution controls and/or management practices, conduct visible emissions monitoring, submit semi-annual reports to provide compliance status and conduct record keeping.
For more information, see the Asphalt Rule published at EPA’s website and SBEAP assistance tools that include a fact sheet, Notification letter and Sample Initial Notice.
For more information about Tennessee's Small Business Environmental Assistance Program, please contact the program at 1-800-734-3619 or by email at bgsbeap@tn.gov.